Pentair MiniMax NT Heater important safety instructions For Your Safety - Read Before Operating

MiniMax® NT Heater

Digital Display Temperature Controller (DDTC)

Installation Instructions

	IMPORTANT SAFETY INSTRUCTIONS
	READ AND FOLLOW ALL INSTRUCTIONS
	SAVE THESE INSTRUCTIONS
	Table of Contents
SECTION I.	INSTALLATION	2
SECTION II.	WIRING	2
SECTION III. INTRODUCTION OF DDTC		7
SECTION IV.	SET UP	8
SECTION V.	LED INDICATORS	8
SECTION VI.	TEMPERATURE SETTING	9
SECTION VII.	HEATING MODE SELECTION	9
SECTION VIII.	REMOTE CONTROL	9
SECTION IX.	TROUBLE SHOOTING	10
SECTION X.	MINIMAX NT HEATER DDTC RETROFIT KIT PARTS	12

This instruction is to be used with the DDTC Retrofit Kit (P/N 472377) to replace the 6800 Temperature

Controller for all Pentair Pool Products NT Heaters.

DANGER

FOR YOUR SAFETY – READ BEFORE OPERATING

This product must be installed and serviced by a professional service technician qualified in pool/spa heater installation and maintenance. If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury or loss of life.

WARNING

Before installing this product, read and follow all warning notices and instructions which are included. Failure to follow safety warnings and instructions can result in severe injury, death, or property damage.

Call (800) 831-7133 for additional free copies of this manual.

Important Notice

Attention Installer.

This manual contains important information about the installation, operation and safe use of this product. This information should be given to the owner/operator of this equipment.

Pentair Pool Products

1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151

10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400

Rev. B 1-20-04 1 P/N 472299