|
|
|
|
| Page 15 | |
|
|
|
|
|
| |
3.4 | Heater Connection | 3.4.2 | Guidelines for Sophisticated Diagnostic | |||
The heater connection section applies to all |
| Communication to LX Heaters | ||||
1. | Remove the LX GUI from the heater. | |||||
heaters or heat pumps with thermostatic circuitry | ||||||
of 24 VAC or less (see pages 15 thru 17 for brand | 2. | Confirm the LX and AquaLink RS software | ||||
specific installation). |
| revisions are compatible (see table). | ||||
NOTE | If you are connecting a heater with thermostatic | 3. | Run a | |||
| circuitry of 120 VAC or greater, do not connect |
| red, | |||
| to the green, |
| red, | |||
| connect the heater to a high voltage relay in |
|
|
| ||
| the Power Center and plug the spare relay into |
|
|
| ||
| LX Software Revision | AquaLink RS Software | ||||
| the Electric Heater relay socket located on the | |||||
|
|
| Revision | |||
| upper right hand corner of the Power Center |
|
| |||
| PCB. | C10, C11 or later | PDA 1.0 or later | |||
3.4.1 | Jandy Brand Heater Connections | NOTE | If connecting more than two (2) items to the RS | |||
1. | Connect two #14 gauge wires, designed for |
| Power Center red, | |||
| use in hot environments, to the #1 and #2 |
| PCB is required. |
|
terminals on the green,
2. | Connect the other ends of the #14 gauge | PDA | GRN YEL BLK RED |
| wires from Step 1 to the Fireman's Switch | 4 3 2 1 | |
| terminal bar in place of the factory installed |
|
|
| wire loop. |
|
|
3. | Do not disconnect high limit or pressure | OPTIONAL |
| switches. |
|
4. | Turn the heater thermostat(s) to maximum |
|
| setting. |
| |
5. | Turn the heater switch to the ON position. | Wire | |
RS Power | |||
| For dual thermostat heaters turn switch to | Center | |
| Spa position. |
|
|
Green | #14 |
| |
| Terminal Bar | Gauge |
|
|
| Wire |
|
1 | RED | |
2 | BLK | |
3 | ||
YEL | ||
4 | ||
GRN | ||
|
Heater Toggle |
|
Switch To On | LX GUI |
Power Center PCB/Bezel
Factory | Figure 10. LX Heater Connection to Power Center |
Heater |
Installed | Thermostat To | 3.4.3 Other Brands Heater Connections |
Wire Loop | Max. | To set up heater connections on heaters |
|
| |
| Heater | manufactured by Hayward, Pentair, and Raypak, |
| please refer to the Installation Manual provided | |
Terminal 1 | Wiring | |
| with these heaters. |
Terminal 2
Heater Fireman's Switch
Connection