D. Installing the Twist Lock Pressure Relief Valve (Wall Fitting)
1.Take out any existing pool cleaner and/or wall fitting.
2.Turn on the filtration pump and booster pump, flush out the plumbing line.
3.Turn off filter pump and booster pump.
4.Remove the Wall Adapter from the Wall Fitting and screw Adapter by hand into the dedicated line. Turn until tight.
WALL ADAPTER
INSTALLED
QUICK DISCONNECT
QUICK
LOCKO-RING
PEG
5.Take the Wall Fitting and Twist Lock the Wall Fitting into the Wall Adapter 1/4 turn and pull out, to a snug fit. Once the Wall Adapter is secure, you can now twist lock and unlock to remove Wall Fitting with ease from the Wall Adapter.
E. Cutting the Feed Hose
The Hose assembly comes in 5 sections now covering approximately 30 ft. of the pool, which provides ample hose for most residential pools. The
1.Take Feeder Hose out of box (it will be approximately 30 feet long). Before installing the unit, you should lay the feed hose out straight in the sun, (for one day if possible). The hose has been curled up in the box and sometimes will go around in a circle. If this happens, take the first or second section of hose from the wall and reverse it, (turn it around). You might have to reverse both sections to correct the problem. Make sure the feed hose is cut and installed properly.
2.Measure how deep your pool is by using your telepole or the clear end of the feeder hose. Cut the clear (soft) hose equal to the depth of your pool. (Hint: the grate or domed main drain at the bottom is usually the deepest point.)
Example: The clear (soft) hose is 10 ft. long, if the pool is 8½ ft. deep, cut 1½ ft. off of the clear (soft) hose. If the depth is greater than 10 ft., do not cut the clear (soft) hose.
Telepole / Clear (Soft) Hose
Measure and Mark the Water Level
Deepest End of Pool
Main Drain
3
LEGEND® PLATINUM INSTALLATION MANUAL
