
EXAMPLE OF HOSE ASSEMBLY BEFORE CUTTING TO LENGTH
STEPS
1.With the feed hose assembly attached to the pool wall, hold the feed hose assembly by the opposite end with the clear hose and walk the perimeter of the pool to locate
the farthest point on the perimeter from the wall fitting without stretching the hose assembly.
2.Measure the distance that the hose assembly extends beyond the pool perimeter farthest point located in Step 1 — (7½ ft. in this example).
3.Cut half of the length obtained from Step 2 — (3¾ ft. in this example), equally from each of the 10 foot lengths of white or grey hose on either side of the marked swivel.
WALL FITTING
SWIVEL
REMOVE EXCESS MATERIAL
FROM HOSE ON EITHER SIDE OF
MARKED SWIVEL AS DESCRIBED
IN STEPS 2 AND 3.
FLOATS
10 FOOT WHITE OR GREY HOSE SECTION
| FLOATS |
MARKED SWIVEL | SWIVEL |
|
10 FOOT
WHITE OR GREY
HOSE SECTIONFLOATS
10 FOOT | BACK UP |
VALVE | |
SOFT HOSE |
|
FARTHEST POINT OF POOL PERIMETER FROM WALL FITTING
7½ FT.
EXAMPLE DIMENSION
(Your Measurement May Differ)
NOT TO SCALE
EXAMPLE OF FINISHED HOSE ASSEMBLY AFTER CUTTING TO LENGTH
STEPS
4.Reassemble the hoses using the supplied mender nuts as shown in FIGURE 1.
5.Your complete finished hose assembly should look like this. The end of the 30 inch clear hose should reach just to the furthest edge of the pool perimeter as shown.
WHITE OR GREY HARD HOSE SECTION
WHITE OR GREY HARD HOSE SECTION (WALL FITTING SIDE)
MARKED SWIVEL
|
| WHITE OR GREY |
|
|
| HARD HOSE SECTION |
|
| WHITE OR GREY | (CLEANER SIDE) | FIGURE 1 |
|
| ||
|
|
| |
MARKED SWIVEL | HARD HOSE SECTION |
|
|
| SOFT HOSE | END OF |
|
| (Cut to your pool depth) | SOFT HOSE |
|
|
| (End remains 30 in.) |
|
BACK UP VALVE | FURTHEST POINT |
| OF POOL PERIMETER |
4 | FROM WALL FITTING |
| |
|
|
LEGEND® PLATINUM INSTALLATION MANUAL