Pentair Time Master Operating Instructions, LOW VOLTAGE WlHlNti UlAGHAM, General Control Features

LOW VOLTAGE WlHlNti UlAGHAM

Do not untwist pairs.

It is neccessary to retain wires in pairs so that appropriate connections can be identified.

OPERATING INSTRUCTIONS

GENERAL CONTROL FEATURES

FILTER PUMP OFF DELAY. This causes the filter pump to run an additional 4 minutes every time it is turned off. The purpose of this is to protect the gas heater and plumbing from possible scale build-up and thermal stress. These occur when residual heat in the gas heater is not allowed to dissipate after heater is turned off.

POOLCLEANER ON DELAY. Every time the pool cleaner pump is turned on, this circuit prevents it from running until 4 minutes have passed. This protects the pump from damage caused by air in the water lines that may have entered into the plumbing since it was last used.

	TIME CONTROL
EQUIPMENT B U l T O N FUNCTIONS:
FILTER:	Turns filter pump ON and circulates POOL water.
CLN R:	Turns filter and cleaner pumps ON. (Cleaner delayed 4 minutes)
SPA:	Turns filter pump ON and circulates SPAwater. Allows heater to
	operate. Overrides CLNR key and turns pool cleaner pump OFF,
	even if CLNR "flag" is present.
AUX1:	Turns electrically controlled function ON. (lights, jets, etc.)

I I I

0 0 0

n k k k

Z Z Z Z o m m m

t t t t

X O J Z

J W W (+1 :

m (1:0

I I I

0 0 0

n k k k

Z Z Z Z o m m m

t t t t

X 3 X Z

d J J ( 1 :

m m m o

-

(1:

:IN I Ell

LA

- ~ m

a a a

r 5 5 p

< < < N	HIGH VOLTAGE RELAYS
J J J +

t t t t

x k x n

-I I -I w

m 3 m r r

R 6

R 7

TEMPERATURE CONTROL

WATER TEMPERATURE Display:

Pool temperature is displayed when the pool is operating, spa temperature when the spa is operating. If filter pump is off, display may be meaningless

THERMOSTAT:

Desired pool or spa temperature is set here.

	HEATER CONTROL
SWITCH POSITIONS:
PO0L:	Allows heating of pool to the preset temperature level.
SPA:	Allows heating of spa to the preset temperature level.
OFF:	Allows no heating.

HEATER ON Light:

When lit, indicates that heater is on.

STATUS DISPLAY

The presence of a light next to an equipment label indicates that it is ON. The absence of a light indicates OFF.

DELAY CANCEL B U l T O N FUNCTIONS:

FILTER:	To override the Filter Delay Circuit, press CANCEL OFF DELAY
	button. Provided that there is no "flag" present at either
	FILTER, CLNR or SPA buttons, the filter pump will shut off
	immediately.
CLNR:	To override the Cleaner Delay Circuit, press CANCEL ON
	DELAY button. Provided that there is a "flag" present at the
	CLNR button, the pool cleaner pump will start immediately.
	If SPA is on, CLNR is inoperative.