Changing Pump Speeds
Saving Adjusted Speed
Resetting Speeds to Factory Default
You can change these presets in 10 or 20 RPM increments.
Each setting can be adjusted to run at speeds between 400 RPM and 3450 RPM. Typically the lower speeds are used for filtration and heating. The higher speeds can be used for spa jets, water features, and priming.
Press the Up/Down button to increase or decrease pump speed.
Press and quickly release to increase or decrease in 10 RPM increments.
Press and hold the Up/Down button to continuously increase or decrease the pump speed (20 RPM increments)
Press and hold Speed button for at least 3 seconds to assign current speed.
Press the Stop button.
Press and hold all four Speed buttons simultaneously for three seconds. Power off the drive and
IntelliPro™
10
