Control Panel
1
2
5
6
3 4
1Speed 1, speed 2, speed 3, and speed 4 button/LED: Press one of the speed buttons to select the desired preset pump speed. The pump
preset speeds are:
Speed 1 (750 RPM), Speed 2 (1500 RPM), Speed 3 (2350 RPM), and Speed 4 (3110 RPM). The speed button LED is on when the selected button is pressed. If the pump is running and the Up/Down button is used to adjust the speed, the selected speed LEDs will go off.
2Up/Down button – While the pump is running, press Up or Down button to increase or decrease the pump speed. To save the new pump speed, press any one of the four speed buttons for three seconds to assign the speed to the selected button (the LED be on). Four adjusted pump speeds can be assigned to the speed buttons. When the pump is using an adjusted speed and the pump is powered down, the next time, the pump is powered up, the pump will use the same speed.
3Start button/LED: Starts the pump using a selected or adjusted speed. This LED is on when the pump is running.
4Stop button: Press this button to stop the pump.
5On LED: This green power LED is on when IntelliPro is powered up.
6Alarm LED: The red LED fl ashes when an error condition occurs.
The green LED will fl ash a certain number of times indicating a specific error condition.
IntelliPro™
6
