Pentax IC-360 manual Assigning a VersaCam’s IP Address, Configuring Administrator’s Data

B. Assigning an IP address and configuring administrator’s data with the setup program

1)Starting the VersaCam IC Series Setup Program Click the file ‘Setup.exe’ on your PC.

When the setup program is executed, the setup program detects and shows every VersaCam IC Series connected to the local network.

Among the VersaCams, choose the one to which you want to assign a new IP address. (The default address in the figure is 211.53.133.223). To choose a VersaCam, click on its MAC address or IP address.

When a VersaCam is selected, an IP address shows in the ‘Selected IP Address’ window. You must key in a password in the blank ‘Admin’s Password’ window to assign (or change) the IP address to the VersaCam. The default password is ‘admin’.

You can now change the IP address by clicking ‘Change IP Addr’ button or set up by clicking ‘Start Configuration’ button.

If the VersaCam has any problems, you can reboot without turning off the power supply. The ‘Reboot’ button works as a reset switch.

2) Assigning a VersaCam’s IP Address

After keying in the administrator’s password, click the ‘Change IP Addr’ button to change your VersaCam’s IP address. Type in a new IP address that you are going to assign to your VersaCam. Then confirm it with the ‘OK’ button.

3) Configuring Administrator’s Data

After assigning a new IP address to a user’s VersaCam, you may configure the administrator’s data for that camera. When you click ‘Start Configuration’ button, the Setup program automatically connects you to the Admin page of

VersaCam Homepage. (For more detailed information, refer to Chapter VI ‘Configuring Administrator’s Data at the Homepage’)

10 VersaCam IC-360 User’s Guide