4.TURN ON THE LIGHT METER SWITCH

Push up the switch button with your thumb. Through the viewfinder, you will observe the movement of the meter's needle on the right side of the ground glass. Be sure to turn off the meter's switch when not actually taking readings.

5.ROTATE DIAPHRAGM RING

The needle moves up and down with the turn of the diaphragm ring. When the needle rests at the center, you will get correct exposure. If the needle does not come to the center no matter how far you turn the diaphragm ring, change the shutter speed. When the needle is off center and close to the (+) mark, you will get over-exposure: change the shutter speed to a faster setting. If the needle is closer to the (-) mark, you will get under- exposure: change the shutter speed to a slower setting.

6. RELEASE THE SHUTTER

Hold your camera firmly and trip the shutter. When the shutter is released, the meter switch will automatically turn off, and the needle will remain fixed off

and underneath the center. The diaphragm will reopen to its full aperture and the overall image will look brighter. Cock the rapid wind lever for the next picture. (When taking a series of pictures under the same lighting conditions, it is not necessary to repeat instructions 4 and 5.)

Reproduced for Historical & Reference purposes by Paul M. Provencher -

7

http://whitemetal.com

 

Page 9
Image 9
Pentax Spotmatic II manual Turn on the Light Meter Switch, Rotate Diaphragm Ring, Release the Shutter