Problem

Cause

Remedy

 

 

 

Lock focus on another object located at

 

 

Subject is difficult to

same distance (press shutter release

 

 

focus on with

button halfway), then aim at target and

 

 

autofocus

press shutter release button fully (p.41),

 

 

 

or use Manual Focus mode. (p.86)

 

 

 

Position subject in focus frame in middle

 

Subject is not in

 

of LCD monitor. If the subject is outside

 

Subject is not in

the focusing area, aim the camera at the

 

focus

 

subject and lock the focus (press shutter

 

 

focusing area

 

 

release button halfway), then compose

 

 

 

 

 

 

picture and press the shutter release

 

 

 

button fully.

 

 

Subject is too close

Set focus mode to q. (p.85)

 

 

Focus mode is set to q

Normal pictures will be out of focus if

 

 

taken with focus mode set to q.

 

 

Flash mode is set to a

Set to Auto or b (Flash On). (p.87)

 

 

(flash off)

 

 

Flash does not

Drive mode is set to 1

 

 

or c

 

 

discharge

Focus mode is set to

Flash will not discharge in these modes.

 

 

s

 

 

 

 

 

Shooting mode is set

 

 

 

to C, yor Q

 

 

USB connection

 

 

 

with computer

USB connection mode

Change the USB connection mode to

 

does not work

is set to [PictBridge]

[PC]. (p.175)

 

properly

 

 

 

USB connection

USB connection mode

Change the USB connection mode to

 

with printer does

 

is set to [PC]

[PictBridge]. (p.154)

 

not work properly

 

Static electricity may occasionally prevent the camera from operating correctly. If this

 

should occur, try removing and then reloading the battery. If the camera turns on and

 

operates properly, this indicates that there is no malfunction. You can use the camera

9

as usual.

 

 

 

 

 

Appendix

195