Preparing the Cabinet for Use – Direct Draw Dispensers Self-Contained
Parts List
■Faucet Standard.
■Faucet Head Assembly.
■Black Connector Hose 3⁄16” x 3’.
■5⁄16” Air Hose.
■Spanner Wrench.
■Bag of Miscellaneous Parts.
Suggested Tools Required
■#2 Phillips Screwdriver.
■Spanner Wrench (included).
■#10 Crescent Wrench.
■9/ 16” Allen Wrench.
■5/ 16” & 3/ 8” Nut driver.
■Power driver.
Uncrating and Inspection
Remove all crating material before operating. Carefully inspect cabinet for hidden damage. If damage is discovered, file your claim immediately with the transportation company. Perlick is
not responsible for damage in transit.
Placing the Cabinet
Push the cabinet into place using rollers when necessary. Important: Proper air flow around the condensing unit is necessary for efficient operation. Never obstruct the air flow in and out of the condensing unit.
Leveling the Cabinet
When the cabinet is in place, check installation with a carpenter’s level. A slight pitch to the drain side is desired. Water may accumulate if the cabinet is pitched to the opposite side.
Installing Casters or Legs (Optional)
Attach casters to the cabinet bottom in the holes provided. Use supplied 1/ 4”- 20 x 3/ 4” hex head
Installing the Faucet and
Dispensing Head
Before you begin: Wash tapping devices and faucet. Flush beer, tapping device and faucet lines with fresh water.
■Apply RTV around the base of the dispensing head to seal it to the top. Align the dispensing head over the holes on the cabinet top and use screws provided to secure standard to cabinet top. Wipe off excess RTV to complete the seal.
■Attach faucet to standard using spanner wrench to tighten coupling. Attach faucet handle to faucet.
■Insert flexible plastic air hose six to seven inches into bottom of faucet standard. Secure hose with tie wrap (supplied).
Plumbing
The floor drain in the right rear corner is equipped with a 3/ 4” female pipe thread connection with side or bottom access for beer drainer waste.
■Remove either side or bottom drain plug with an
allen wrench and attach a 3/ 4” male pipe (provided by plumber) to an external drain connection.
Evaporator condensate has been plumbed to a condensate pan located in the compressor housing.
CAUTION: Do not overtighten drain fitting as it may damage the threads.
NOTE: The end of the CO2 line extends through a sleeve on the side of the cabinet in the machinery compartment. Connect this line to the pressure supply with a hose and fitting.
Electrical
The cabinet must be connected to a separately fused power source (see electrical specification plate) and grounded in accordance with National and Local Electrical Codes. Caution: Do not attempt to operate the equipment on any other power source than that listed on the Electrical Specification plate.
WARNING!
To avoid compressor damage,after returning cabinet to an upright position, let unit stand for
24 hours before plugging it in and running the unit.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Form No. Z2280
3
