General Information
Refrigeration and Temperature Control
The cabinet is equipped with a
|
| 4 |
| 3 | 5 |
|
| |
2 |
| 6 |
| 1 | COLD |
|
| |
|
| OFF |
The condenser fan motor turns off and on with the compressor. The evaporator fan motor is on all the time.
NOTE:
Cabinet Temperatures lower than 34° will not allow for proper defrosting of the evaporator coil. If defrosting is necessary, turn the control knob to the OFF position until coil is defrosted.
Cleaning the Cabinet
Use a mild detergent and water to clean the inside and outside of the cabinet. Dry thoroughly. Never use a scouring pad or abrasive cleanser.
Note: An industrial strength, commercial cleaner can be used to clean the outside of painted cabinets.
Adjusting the temperature
The temperature control is inside the cabinet on the
■Colder Temperatures:
Turn the adjusting screw clockwise (to the right).
■Warmer Temperatures:
Turn the adjusting screw counterclockwise (to the left).
■Temperature Control “OFF”:
Turn the adjusting screw completely counter- clockwise to the “O” position until a click is noted.
Cleaning the Condenser
Use a long handled, stiff brush to clean the dirt from the front surface of the condenser. Keeping the condenser free from dust and dirt will ensure efficient operation.
Caution: Do not bend the fins while brushing the front of the condenser.
Condenser
The condenser (located behind the front grille cover) should be inspected every 30 days and cleaned, if necessary.
Failure to keep the condenser clean will cause a loss in condensing unit efficiency.
Recommended Cleaning Agents
Job | Cleaning Agent* | Comments |
|
|
|
Routine Cleaning | Soap, ammonia, detergent | apply with sponge or cloth. |
|
| Can be used on all finishes. |
|
|
|
Fingerprints and smears | areal 20, | Provides barrier film to minimize |
| O’Cedar Cream Polish | fingerprints. Can be used on all finishes. |
|
|
|
Stubborn stains and | allchem Concentrated Cleaner, | rub lightly, using dry or damp |
Discolorations | Samae, Twinkle, Zud Restoro, | cloth in the direction of polish |
| grade F or FFF Italian Pumice, | lines on the stainless steel. |
| Whiting or Talc, Liquid Nu Steel, |
|
| Copper’s or Revere Stainless Steel |
|
| Cleaner, Lumin Cleaner, |
|
| Cameo Copper Cleaner, Allen Polish |
|
| highlite, |
|
|
|
|
*Use of propriety names is intended only to indicate a type of cleaner and does not constitute an endorsement.Omission of any proprietary cleaner does not imply its inadequacy. All products should be used in strict accordance with instructions on
the package. Note: Do Not Use Steel Wool or Scouring Pads to clean stainless steel.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
5 | Form No. Z2279 |
Rev 08.01.07 |
