|
|
|
|
| Models SDB/SDP Installation & Operation Manual | |
|
|
|
|
| ||
|
|
|
|
| ||
|
|
| Adjustments | |||
|
|
| Never attempt to repair or | 5. Plug new LED into harness and secure to | ||
| DANGER | |||||
|
| perform maintenance on | housing using screws removed in step 2. | |||
|
| |||||
the unit until the main electrical power to the | 6. Snap LED cover into place. | |||||
unit has been disconnected! | ||||||
Sliding Doors | ||||||
Shelving Adjustment | ||||||
Removing / Installing | ||||||
|
|
| Completely empty shelf or | |||
| CAUTION | 1. To remove the sliding door, simply grasp the | ||||
|
|
| drawer before removing. | door on each side and lift up off the bottom | ||
1. Open the door. Tilt the shelf and remove it | ||||||
track, then tilt outwards and pull down to | ||||||
| from the unit | |||||
| remove from upper track. | |||||
2. Reposition each bracket separately. Grasp the | ||||||
2. To reinstall sliding door, place door in upper | ||||||
| middle of the bracket, pull the front end up and | |||||
| track, making sure to engage the bracket | |||||
| out, then forward to remove it. See Figure 3. | |||||
| (Figure 5), lift door up into the track and place | |||||
3. Place brackets at desired location and reinstall | into the bottom track. | |||||
| shelf(s). | Adjusting Door Spring Tension | ||||
|
|
|
|
| A tension spring is located in the upper track of | |
|
|
|
|
| each door. To increase or decrease spring tension, | |
|
|
|
|
| remove the Phillips screw and position the bracket | |
|
|
|
|
| in one of three detentes and reinstall screw. The | |
|
|
|
|
| detente farthest to the left provides the least | |
|
|
|
|
| amount of tension. |
Figure 3. Shelf Bracket
LED Light Replacement
Unplug LED Light Strip
LED Light Strip
NOTE: Units are shipped from the factory with springs set at the weakest setting.
Make sure door engages bracket
Lens Cover
machine screw (Qty. 2)
Figure 4. Interior LED Light
1.Open the door.
2.Using a flat blade screwdriver, carefully pry off the lens cover.
3.Remove the two screws securing LED light to housing.
4.Unplug the LED from the wiring harness.
Figure 5. Removing/Installing Sliding Door
Sliding Door Lock
Each set of sliding doors is equipped with a keyed lock located on the bottom of the right side door. To lock the doors, place the lock lever in the DOWN position and lock with the key. Unlock with the key and place lever in the UP position to open.
Printed in USA | 6 | 0213 |