2.Follow Instructions

All installation, operation and other instructions should be followed.

3.Warnings

All warnings on the 200P and in the Owners Manual should be strictly adhered to.

4.Water and Moisture

The 200P should not be used near water, for example near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool, etc.

5.Rack / Wall / Ceiling Mounting

The 200P should be rack mounted only in a heavy duty rack or stand that is recommended for audio equipment use. Mounting to a wall or ceiling should be via a heavy duty bracket or shelf designed for audio equipment use.

6.Heat

The 200P should be situated away from heat sources such as radiators, stoves, or other appliances that produce excessive amounts of heat. Always ensure the 200P heat sinks have adequate ventilation enabling air circulation both above and below. Do not place the 200P directly onto carpeted surfaces.

7.Power Sources

The 200P should be connected to a mains power supply only of the type described in the operating instructions, or as marked on the rear of the 200P.

8.Power Cord Protection

The mains power supply cord should be routed so that it is not likely to be walked on or pinched by items placed on or against it. Pay particular attention to the cord at power points, convenience receptacles, and the point where it exits from the 200P.

9.Cleaning

When cleaning ‘P’ series product use luke warm water with a few drops of a mild non caustic detergent .

DO NOT USE SOLVENTS.

10.Non-use Periods

The mains power cord of the 200P should be unplugged from the mains/line outlet when the unit is to be left unused for long periods of time.

11.Object and Liquid Entry

Care should be taken so that objects and/or liquids do not accidentally fall inside the 200P.

12.Damage Requiring Service

The 200P should be serviced by qualified service personnel if any of the following occur :

a.The mains power-supply cord, and/or plug have been damaged

b.Objects have fallen, or liquid has been spilt into the 200P

c.The 200P has been exposed to rain and/or excessive moisture

d.The 200P does not appear to operate normally, or exhibits a marked change in performance

e.The 200P has been dropped, or the chassis damaged.

13.Servicing

The user should not attempt to service the 200P beyond those means described in the owners manual. All other servicing should be referred to qualified service personnel.

14.Grounding or Polarisation

Precautions should be taken so that the grounding or polarisation of the 200P are correct, and are maintained through-out the entire system.

WARNING: THE 200P IS A HIGH POWERED CONVECTION COOLED AMPLIFIER. THE FINNED OUTER HEAT SINKS MAY BECOME VERY HOT WHEN DELIVERING HIGH VOLUME LEVELS - TO AVOID INJURY CARE SHOULD BE TAKEN NOT TO TOUCH THE HEAT SINKS DURING OPERATION.

IMPORTANT INFORMATION

Always make sure the volume control of your preamplifier or source unit is set to zero and the mains/line supply disconnected from your 200P prior to performing any switching functions or connection alterations of any type to your system. This caution also applies

3