Pertech Resources Inc. November 2005 220321A 19
Font
There are three font options available in all control lan-
guages except the A470 Mode they are Standard - Com-
pressed - Expanded. The table below details each of the
font options pitch and column capabilities
Inkjet Font Pitch
(Char/Inch)
Columns
(Char/Line)
Standard 16 40
Compressed 22.8 57
Expanded 13.2 33
The A470 control language has the following font capabili-
ties: 33, 36, 40, 44, 50, 57, 66 Characters Per Line
RS232 Interface
Baud Rate - Data Bits -Stop Bit - Parity and Flow control
settings are selectable through the conguration menu.
Flow control is designated as Hardware = DTR, DSR, or
RTS, CTS depending on the printer control language be-
ing used. Software ow control is Xon/Xoff.
USB Interface
Change the USB option to “Serial Number” for the USB
driver to assign serial numbers for each printer that is
installed. The Model number default selection allows for
a 5300 printer to be removed and a new 5300 printer to
be installed without the Operating System detecting and
installing a new driver.
Hardware
The Mechanism Model identies the printers current
model setting, this parameter can only be adjusted with
the use of command codes. This parameter is set at the
factory and should not require change.
The option for Validation Clamp default to be changed
to the Open position is only available in the A470 mode
control language.
The time allowed for the user to insert a form is selectable
up to 15 minutes.
The Paper Low Stop can be set to enable or disable,
enable will notify the user via the led indicator when the
paper is out.
There are two options for the INK STATUS RESET set-
ting.
1. Automatic (Default Setting) - Allows for the user to
automatically reset the ink cartridge Dot Count Tally,
LOW INK LED and Command Status Notication for a
new cartridge. The cover must be opened and closed an
additional time after the old Ink Cartridge is removed and
before a new Cartridge is installed for the Status to clear.
2. Manual - LOW INK LED Status Notication will occur
when the Dot Count exceeds it preset limit for the car-
tridge. The Dot Count Tally must be reset via Congura-
tion Menu to clear LOW INK LED Status.
Available Fixed Document stop settings are 1.75”, 1.63”
and 1.46” these are available in the one button congura-
tion mode. The Conguration Utility allows the Document
Stop settings to be incrementally set between the .17”
and 1.75”. The validation print eld width is 2.5”, up to 14
lines of print @ 1.75” setting with Validation Lines Per inch
set at 8 LPI.
3 Inches 1 Inch
Print eld is 2.5” Wide
Center Justify
3.25 Inches
Print Zone
2 Inches for 6” Check
1.75”
1.63”
1.46”

Column Alignment is set at the factory and should not be

adjusted.