Re-synchronize the System

1.Remove the Receiver Collar from your pet.

2.Remove the battery from the Receiver Collar. Discharge all power by holding the correction level button down until the LED is no longer illuminated.

3.At the transmitter, move the Boundary Switch from the low to the high position.

4.Slowly adjust the Boundary Control Dial up to 8, down to 1 and then back to the #4 position.

5.Standing within 5-10 feet of the Transmitter, reinsert the battery into the Receiver Collar.

6.Test the Boundary and verify operation by walking out into the Pet Area until your Receiver Collar responds. (With the Transmitter set to 4, it should activate approximately 40-50 feet away).

Once you are confident that the system is working, reset the Transmitter controls to the original setting.

221-800-732-2677