Petsafe RFA-67 manual Connect the Wires to the Fence Transmitter, Prepare the Receiver Collar

Step

4

Additional Boundary Wire	Acres	Feet of Wire Needed
Extra direct burial Boundary Wire can be purchased in 500 foot spools	1/4	415
at the store where you purchased the kit or through the Customer
	1/3	480
Care Center at 1-800-732-2677.
	1/2	590
Note:When adding BoundaryWire, it must act as a continuous loop.
	1	835
The table at right indicates the approximate length of Boundary Wire
	2	1180
needed for a square, Single Loop layout. Length will vary due to the
	5	1870
amount of twisted wire and layout used.
	10	2800
____________________________________	______________

Connect the Wires to the Fence Transmitter

Boundary Wire (4A)	4A
1. Run the Boundary Wire to the Fence Transmitter through a window, under
a door, through a crawl space vent, or any other appropriate available access.
You can also drill a hole through your wall.
2. Strip the ends of the Boundary Wire approximately one-half inch.
3. Insert the Boundary Wires into the Boundary Wire Terminals on the Fence
Transmitter. Make sure the wires do not touch each other at the terminals.
4. Turn the Boundary Width Control knob to 10. This will set the Warning Zone		}TerminalsBoundary Wire
at the maximum width.
5. Plug the Power Adapter into the Power Jack and a 120-volt outlet.		Loop Indicator
6. The Power Light and Loop Indicator Lights should come on. If this does not		Light
		Power Light
happen, see the “Troubleshooting” section.
	Power	Boundary Width
	Jack
Lightning Protection		Control

Lightning strikes within 1-2 miles of your installation can create power current

surges or spikes which may damage your unprotected electronic pet containment system. The LP-4100-1 Lightning Protector is designed to protect your In-Ground Fence™ from surges or spikes that can reach it via your AC power connection and/or your buried Boundary Wire.

You may purchase a Lightning Protection Kit through the Customer Care Center at 1-800-732-2677. The Lightning Protection Kit protects the system against surges that travel through the power source and/or the Boundary Wire.

Step

5

Prepare the Receiver Collar

Your Receiver Collar comes with short Contact Points. Long Contact Points for pets with long or thick hair are available through our Customer Care Center at 1-800-732-2677. Tighten the Contact Points using Test Light Tool (5A) one-half turn beyond finger tight. Check the tightness weekly.

To Insert and Remove the Battery

Note: Do not install the battery while the Receiver Collar is on your pet.

This Receiver Collar utilizes a replaceable PetSafe® battery (RFA-67).This unique battery is designed to make battery replacement easier and increase water protection.

To insert the battery, align the symbols on the battery (arrow) and Receiver Collar (triangle) (5B). Use the edge of the Test Light Tool to turn the battery clockwise until the arrow lines up with the lock symbol on the housing.

To remove the battery, turn the battery counter-clockwise using the edge of the Test Light Tool (5C). DO NOT attempt to cut into or pry open the battery. Be sure to discard the used battery properly.

Battery life will vary depending on how often your pet tests the system and receives a Static Correction. Check the Receiver Collar every month to ensure the battery is working properly.

Areplacement PetSafe® battery (RFA-67) can be found at many retailers. Contact the Customer Care Center at 1-800-732-2677 or visit our web site at www.petsafe.net to locate a retailer near you.

8 1-800-732-2677