Petsafe RFA-67 manual Set the Boundary Width Test the Receiver Collar, Over Correction Protection

Over Correction Protection

In the unlikely event that your pet “freezes” in the Static Correction Zone, this feature limits the static correction duration to a maximum of 30 seconds. While the system locks out further static correction, the warning tone will continue until the pet leaves the Static Correction Zone.

Step

6

Set the Boundary Width

and Test the Receiver Collar

The Boundary Control Switch on the side of the			6A	6B
Fence Transmitter has three settings (6A). Setting B						5
is used for most properties.The following table will				4			6
				3			7
indicate the setting you should use.				2			8
Amount of Wire	Setting			1			9
				0			10
Up to 1300 feet	B
1300-2400	C
Greater than 2400 feet	A
Use the Boundary Width Control knob to set the				4	5		6
				3			7
width of the Warning Zone and Static Correction				2			8
				1			9
Zone (6B). Set the Boundary Width as wide as
				0			10
possible to give your pet the widest Warning and
Static Correction Zones without reducing the
Pet Area too much. We recommend a 12-20		6C		6D
foot Boundary Width.
Note:The BoundaryWidth Control knob does not
change the Static Correction Level.
To identify the Warning and Static Correction
Zones, make sure the Receiver Collar battery is
properly installed and the Test Light Contacts			Test Light Contacts
are touching the Contact Points (6C, 6D). For
best results, select a section of straight Boundary
Wire that is at least 50 feet long. Hold the Test Light			6E	6F
contacts to the Contact Points. (6D).Walk toward the
Boundary Wire with Contact Points pointing up and holding
the Receiver Collar at your pet’s neck level (6E) until the							Boundary
Receiver Collar beeps and the Test Light flashes (6F).
Note:The Receiver Collar is waterproof, which can make the							Wire
beep hard to hear.
If the Receiver Collar does not beep at the desired range,
adjust the Boundary Width Control knob to the desired
setting. Turning the Boundary Width Control knob
clockwise increases the Boundary Width while turning it
counterclockwise decreases it (6B). Repeat this activity as
needed until the Receiver Collar beeps at the desired distance from the Boundary Wire.				6G
The numbers on the Boundary Width Control knob indicate signal strength and are not
representative of Boundary Width footage. If adjusting the Boundary Width Control
knob does not give the desired range, adjust the Boundary Control Switch to another
setting to achieve your desired range. If using a Double Loop, you may need to
increase the separation of the Boundary Wire to achieve desired range.							Boundary
							Wire

The Receiver Collar beeps as a warning tone and ticks when delivering a Static Correction. After hearing the beep, continue to walk towards the wire. The Receiver Collar should tick and the Test Light should flash, indicating the Static Correction as you enter the Static Correction Zone (6G). A warning tone and the flashing of the Test Light indicate that the Receiver Collar and the system are working properly. Test in a number of different areas until you are satisfied that the system is functioning properly.

www.petsafe.net 9