7.While another person holds the Console (13) near the Handlebar (5), connect the wires on the Console to the Extension Wire (59) and the Pulse Wire (61).
Insert the excess wire downward into the Handlebar (5) or upward into the Console (13). Tip: Avoid pinching the wires. Attach the Console (13) to the Handlebar (5) with four M4 x 16mm Screws (90).
8.Orient the Upright (4) assembly and the Pivot Cover (12) as shown.
Slide the Pivot Cover (12) upward to the Handlebar (5). Tip: Bend and flex the Pivot
Cover slightly to slide it over the Handlebar. Attach the Pivot Cover (12) to the Handlebar (5) with four M4 x 16mm Screws (90).
Next, pivot the Handlebar (5) until the hole in the Handlebar is aligned with an adjustment hole in the Upright (4).
Tighten an Adjustment Knob (27) into the Handlebar (5) and into an adjustment hole in the Upright (4). Make sure that the
Adjustment Knob is engaged in one of the adjustment holes.
713
61 |
59 |
5
Avoid pinching | 90 | 90 |
the wires |
|
8
5 |
| |
Hole | 4 | |
Adjustment | ||
Holes | 12 | |
90 | ||
90 | ||
27 | 90 | |
|
9
