5.Apply some of the included grease to an M6 x 70mm Bolt Set (50).

Orient the Handlebar (5) and the Upright (4) as shown.

While a second person holds the Handlebar (5) near the Upright (4), insert the Extension Wire (59) upward through the Handlebar.

Tip: Avoid pinching the Extension Wire (59). Attach the Handlebar (5) to the Upright (4) with the M6 x 70mm Bolt Set (50) and two M8 Washers (43).

Then, attach an M6 x 60mm Bolt Set (51) through the lower bracket on the Handlebar (5).

5

50

43

5

59

 

 

 

Grease

5143 50

51 4

Avoid pinching the

Extension Wire (59)

6. The Console (13) can use four D batteries (not

6

 

 

included); alkaline batteries are recommended.

Screw

 

IMPORTANT: If the Console has been

 

Battery

exposed to cold temperatures, allow it to

 

 

warm to room temperature before inserting

 

 

Cover

batteries. Otherwise, you may damage the

 

 

 

console displays or other electronic compo-

 

 

 

nents. Remove the indicated screw, remove the

 

Batteries

 

battery cover, insert the batteries into the bat-

 

 

tery compartment, and then reattach the battery

 

 

 

cover. Make sure to orient the batteries as

 

 

 

shown by the diagrams inside the battery

 

 

Batteries

compartment.

 

13

To purchase an optional power adapter, call

 

 

the telephone number on the front cover of

 

 

 

this manual. To avoid damaging the console,

 

 

 

use only a manufacturer-supplied power

 

 

 

adapter. Plug one end of the power adapter

 

 

 

into the receptacle on the console; plug the

 

 

 

other end into an outlet installed in accordance

 

 

 

with all local codes and ordinances.

 

 

 

 

8

 

 

Page 8
Image 8
ProForm 300 ZLX user manual Avoid pinching Extension Wire, Important If the Console has been