9.Slide the Front Shield Cover (7) upward onto the Upright (4).
While another person holds the Upright (4) near the Frame (1), connect the Extension Wire (59) to the Wire Harness (58).
Insert the Upright (4) into the Frame (1).
Tip: Avoid pinching the wires. Attach the Upright (4) with four M8 x 20mm Patch Screws (74) and four M8 Split Washers (75).
Then, slide the Front Shield Cover (7) down- ward to the Frame (1) and press it into place.
10.Identify the Right Pedal (21), which is marked with an “R.”
Using an adjustable wrench, firmly tighten the Right Pedal (21) clockwise into the Right Crank Arm (19).
Tighten the Left Pedal (not shown) counter- clockwise into the Left Crank Arm (not shown). Adjust the strap on the Right Pedal (21) to the desired position, and press the ends of the straps onto the tabs on the Right Pedal. Adjust the strap on the Left Pedal (not shown) in the same way.
9 |
|
|
|
|
Avoid pinching |
| 4 |
|
|
the wires | 7 |
|
| |
|
|
| ||
| 75 | 1 | 59 |
|
74 | 58 |
| ||
|
| 75 | 74 | |
|
|
| ||
|
|
| 75 |
|
10 |
|
|
|
|
19 |
|
| Strap | |
|
|
| ||
21
Tab
11.Make sure that all parts are properly tightened before you use the exercise bike. Note: Some hard- ware may be left over after assembly is completed. Place a mat under the exercise bike to protect the floor or carpet.
10
