5 Feed dog height
Requirement
With the stitch length set at “0” and the needle bar at a position
0.6mm past b.d.c (cylindrical pin in hole “3”, for PFAFF 481) and 0.6 past t.d.c. (cylindrical pin in hole “1”; for PFAFF 483)
1. the feed dog must be positioned in the middle of the needle plate slots when looked at from the side as well as in feeding direction.
2. the feed dog must be at its top point of reversal and must contact the gauge throughout its entire length.
|
| 3 |
|
| 1 |
|
| 1 |
3 |
|
|
|
| 5 |
4 |
|
|
|
| 6 |
X | = | X |
|
| 2 |
●Move feed bar 1 (screw 2) according to requirement 1.
●Lower the presser foot until it rests on the gauge.
●Turn eccentric 3 (screw 4) and eccentric 5 (screw 6) according to requirement 2.
PFAFF 9
