PGS S36R, S27R owner manual Into the Unit and Turn the GAS on

Install battery with “+” side facing out.

GAS LEAK TEST

AFTER SIDE BURNER KIT IS ATTACHED TO CART, TIGHTEN ALL CONNECTIONS, FITTINGS AND SCREWS. PLEASE NOTE THAT DURING TRANSPORT, CONNECTIONS AND SCREWS MAY BECOME LOOSE CHECK ALL.

BEFORE ATTEMPTING TO LIGHT GRILL, BE CERTAIN THE GAS VALVE KNOBS ARE IN THE OFF POSITION. TURN GAS SUPPLY ON CHECK ALL CONNECTIONS WITH A SOLUTION OF 50% LIQUID SOAP, 50% WATER. SOLUTION CAN BE SPRAYED ON WITH A SPRAY BOTTLE OR PAINTED ON ALL CONNECTIONS WITH A BRUSH. IF BUBBLES APPEAR THERE IS A LEAK, TURN OFF GAS, TIGHTEN FITTINGS AND REPEAT THIS CHECK.

PLEASE NOTE!!! ABOVE PROCEDURE IS IMPERATIVE FOR SAFE OPERATION ON YOUR GRILL.

IF THE BURNER FAILS TO LIGHT

IMMEDIATELY TURN CONTROLS OFF TO PREVENT GAS BUILD-UP. WAIT FIVE MINUTES FOR GAS TO CLEAR AND TRY THE ABOVE PROCEDURE AGAIN. IF THE BURNER DOES NOT LIGHT WITH THE ELECTRONIC IGNITION, LIGHT THE BURNER WITH A MATCH OR OTHER HAND HELD IGNITOR. DO NOT TOSS A LIT MATCH

INTO THE UNIT AND TURN THE GAS ON!

IF THE GRILL STILL FAILS TO LIGHT, CHECK THE GAS SUPPLY. YOU COULD BE OUT OF LP GAS OR THE MAIN GAS SUPPLY FOR NATURAL GAS MAY HAVE BEEN TURNED OFF.

USE APPROPRIATE COOKWARE WITH FLAT BOTTOM WHEN USING SIDE BURNER KIT. PYREX TYPE PANS AND OR SIMILAR CONTAINERS ARE NOT TO BE USED ON THE SIDE BURNER AS INTENSE HEAT WILL FRACTURE MATERIAL AND COULD CAUSE HARM OR DAMAGE. ADJUST THE FLAME SO THAT IT ONLY HEATS THE BOTTOM OF THE POT OR PAN TO AVOID THE POSSIBLE LIGHTING OF CLOTHING

ADJUST THE FLAME SO THAT IT ONLY HEATS THE BOTTOM OF THE POT OR PAN TO AVOID THE POSSIBLE LIGHTING OF CLOTHING.

16