Phantom Tech SU0508L installation manual Cutting the Screen Housing Assembly

Cutting the Screen Housing Assembly

It is easy to cut right through the Screen Housing Assembly of the Sure View Screen using a chop saw or hacksaw.

NOTE: All cutting will be done on the upper end of the Screen Housing Assembly. The Mounting

Bracket on the Screen Housing Assembly is A

clearly labeled with CUT and NO CUT zones.

1. Remove the Mesh Lock Adjuster and Sliding

Bar Top Cap from the Screen Housing Assembly by removing their screws with a Phillips screwdriver. (A)

2. Detach the Sliding Bar from the Sliding Bar Bottom Cap, and slide it towards the upper end of the Screen Housing Assembly until it is aligned with the top of the Assembly and the mesh. (B)

3.	Slide the Mounting Bracket until its upper edge
	is aligned with the upper edge of the Screen	C
	Housing Assembly. (C)
4.	With all components aligned, carefully	B
	measure and mark the Screen Housing,

Sliding Bar and Mounting Bracket on all

sides based on the “Length to be cut” dimension calculated on Page 7. (D)

5.Wearing safety glasses, cut straight through all components of the assembly. Use a file to remove any burrs from the cut surfaces.

6. Re-attach the Sliding Bar onto the Sliding	D
Bar Bottom Cap. (B) Make sure that it is
pushed in as far as it will go.

7.Re-attach the Mesh Lock Adjuster and Sliding Bar Top Cap to the Screen Housing Assembly and replace the screws. (A)

8.Slide the Mounting Bracket completely off the Screen Housing and set aside.

9