Install instructions for CI round flush mount models, Page 2
Flange Installation:
Speaker Installation:
1.Using the supplied template, carefully mark the area to be cut out. Using a drywall knife or saw, cut a hole in the drywall and prepare the speaker wires for connection to the speaker terminals. Remove the grille from the mounting flange by pressing it from behind. Insert the mounting flange into the hole.
2.Loosen the flange clamping screws one turn (counter clockwise) to release the clamp. Next, tighten all four flange clamp screws evenly to secure the flange to the drywall. It is best to tighten each screw with the same amount of force (torque). CAUTION: Do not
3.Connect the speaker wires to the
+ Red/positive _ Black/negative
4.Insert the speaker installation tool into two of the screw access holes on the speaker. Carefully place the speaker in the flange; rotate slightly until the speaker surface is even with or slightly recessed into the surface of the flange. While exerting upward pressure, use the tool to rotate the speaker
CAUTION: Do NOT attempt to rotate the speaker by grasping the tweeter!
NOTE: Special instructions for non-QM Flanges
If you are installing a CI round speaker with the QM clamps in a
5.The tweeter may be aimed toward the listening area by gently applying pressure to the inside of the outer edge of the tweeter assembly.
6.Carefully replace the grille by pressing it into the gap between the flange and the baffle. Enjoy your new Phase Technology speaker!
Grille
8650 College Boulevard Overland Park, KS 66210 (888)phase tk www.phasetech.com www.mseaudio.com
