Phase Technology PC-SUB WL-10 Pc-Subwl Series Amplifier Panel, Vibration Isolation Pads

PC-SUB WL SERIES AMPLIFIER PANEL

1.Power/Auto ON/OFF: When this switch is left “ON”, the subwoofer automatically activates upon detection of an audio signal; the subwoofer goes into “STANDBY” after approximately ten (10) minutes of silence. The LED on the amplifier will change from Red to Green when an input signal is detected and the amplifier turns on.

2.Power Input: Connects to a standard AC power outlet with the supplied power cord. The PC-SUB WL is designed to adjust automatically to handle power sources of 100-240V, 50-60Hz. Please be certain that the proper fuse is installed on the amp for the input voltage used locally (see ratings on amplifier panel).

3.Wireless Signal: Blue LED light is on when wireless signal is being received. Press RESET to establish or re-establish a wireless connection. (See wireless set up instructions)

4.Line In: FOR WIRED CONNECTION ONLY: Using a high-quality RCA cable, connect the “SUB OUT” terminal on your receiver or processor to the “LINE IN” terminal on your PC-SUB WL subwoofer. (See wired setup connection instructions.)

5.Low-Pass Frequency Control: If using the crossover setting in your A/V receiver or processor, set this control to “LFE” (Low-Frequency Effects). If using the sub’s internal crossover, choose the setting that sounds best and matches the low-frequency cutoff of your main speakers. It may take some experimentation to find the best sound for your room and your equipment.

WIRELESS	LINE	LO PASS		PHASE	GAIN
	IN	FREQ.Hz.
RESET	3			180°
		80	120
			200
STATUS				0°
		40 LFE			MIN. MAX.
	4		5	6	7

POWER

12

ONCAUTION:

FOR CONTINUED PROTECTION

A G A I N S T R I S K O F F I R E ,

REPLACE ONLY WITH SAME

TYPE FUSE AND RATING.

ATTENTION:

UTILISER UN FUSIBLE DE

RECHANGE DE MEME

T Y P E E T C A L I B R E .

120V60Hz 3A T3.15A L 250V

240V50Hz 1.5A

T1.6A L 250V

PC-SUB WL Subwoofer Amplifier Panel (on back of subwoofer)

6.Phase Control: This adjustment matches the phase - the in and out movement of speaker cones - to that of your main speakers. Adjust this control by listening to music with bass content. The setting is correct when the bass sounds the fullest.

7.Gain Control: This adjustment increases or decreases the power, and thus volume, of the PC-SUB WL. As with the Phase Control and the Low-Pass Frequency Control, it may take some experimentation to find the best sound for your system.

VIBRATION ISOLATION PADS

Included with your PC-SUB WL are a set of four (4) gray disks with an adhesive backing. The Vibration Isolation Pads should be used whenever your subwoofer is installed on any hard flooring surface. These pads prevent the subwoofer from moving against the floor when played at high levels. To use the pads, simply peel off the paper backing from the four disks and apply one pad to the bottom of each of the rubber feet of the subwoofer.

Specifications	PC-SUB WL-8	PC-SUB WL-10	PC-SUB WL-12
Woofer	8” ultra long-throw mica graphite poly	10” ultra long-throw mica graphite poly	12” ultra long-throw mica graphite poly
	cone with NBR surround	cone with NBR surround	cone with NBR surround
Passive Radiator	8” ultra long-throw mica graphite poly	10” ultra long-throw mica graphite poly	12” ultra long-throw mica graphite poly
	cone with NBR surround	cone with NBR surround	cone with NBR surround
Magnet Assembly	12 lbs.	12 lbs.	12 lbs.
Wireless	2.4 GHz uncompressed audio	2.4 GHz uncompressed audio	2.4 GHz uncompressed audio
	streaming	streaming	streaming
Amplifier Power (Watts, continuous)	300	300	300
Amplifier Power (Watts, peak)	900	900	900
Frequency Response (-6 dB)	28-200 Hz (LFE)	24-200 Hz (LFE)	22-200 Hz (LFE)
Low Pass Crossover	40-200 Hz (variable) 24 dB/octave	40-200 Hz (variable) 24 dB/octave	40-200 Hz (variable) 24 dB/octave
Dimensions*	11 3/16” W x 12 1/8” H x 12 5/8” D	13” W x 13 3/8” H x 14 1/2” D	15 7/16” W x 16 1/4” H x 16 7/16” D
Finish	High-gloss Black or Satin Cherry	High-gloss Black or Satin Cherry	High-gloss Black or Satin Cherry
Shipping Weight	33 lbs.	38 lbs.	47 lbs.
			*add 1” to depth for connecting cables

Phase Technology 8650 College Boulevard Overland Park, Kansas 66210 (866) 663-9770 www.phasetech.com

An MSE Audio Group company www.mseaudio.com