Philex RC027 SLX manual How to set up your RC027, TV Set up by auto code search

How to set up your RC027

The RC027 has 3 Device Modes (TV, SAT & SAT+)

The TV section of your RC027 can be set-up either by enter- ing the appropriate codes from the list of codes supplied or by using either the Auto or Manual code search facility.

Instructions for all three methods follow.

TV Set up by auto code search

Probably the easiest way to set-up your RC027, especially if there are a lot of codes listed for your particular brand, is by Auto Code Search.

TV SETUP BY AUTO CODE SEARCH

1.Turn on your TV using your original handset, or the TV set control.

2.Hold down both POWER and MUTE keys on your RC027 simultaneously until the STATUS INDICATOR LED lights up and stays blue (about 4 seconds).

	Blue Status Indicator
TV Device
Indicator key	Step 6

Step 4

&

Step 8

Step 2

3.Release the POWER and MUTE keys The STATUS INDICATOR should still be lit. If not repeat step 2.

4.Press the TV key once. The STATUS INDICATOR and the DEVICE INDICATOR should now both be lit.

5.To search, aim your RC027 at your TV.

6.Hold down the power key for about 8 seconds until the status indicator begins to flash.

7.The Status Indicator will repeatedly flash twice then remain unlit for 1 second, flash twice and remain unlit for 1 second. The Device Indicator key will also flash repeatedly.

8.When a suitable code is found the TV will switch off. When the TV switches off the TV key must be pressed immediately to store the correct code (Please Note: if the TV key is not pressed immediately the search

will continue).

9.Now press the POWER key. If the TV switches on the code has been stored and you can check that other functions work properly.

10.To stop the Auto Code Search at any time press any key

and the remote will go to Manual Code Search.

If you are unable to find a correct code or cannot store the code fast enough try finding the code either using Manual Code Search or by using Setup by Entering Device Code

TV Set up by manually entering code

1.Turn on your TV

2.Look up the brand name of your TV in the Device Code List (See pages 6-8).

3.Look up the 3-digit Device Code next to the brand name of your equipment. If there is more than one code listed for your brand, start with the first code listed and follow the instructions below:

4.Hold down both POWER and MUTE keys on your RC027 simultaneously until the STATUS INDICATOR LED lights up and stays blue (about 4 seconds).

Blue Status Indicator

TV Device

Indicator key

Step 6

Step 4

Step 7

5.Release the POWER and MUTE keys. The STATUS INDICATOR LED should still be lit. If not repeat step 4.

6.Press the TV key once. The STATUS INDICATOR LED and the DEVICE INDICATOR should now both be lit.

7.Use the number keys on your RC027 enter the 3-digit Device Code. If you have entered a valid code, the STATUS INDICATOR will flash once. If you have entered a wrong code, the STATUS INDICATOR will flash twice.

8.Try the keys on your RC027 that correspond to similar keys on your original remote control, especially those you use most. (Note that the RC027 will exit the set-up procedure if you do not press any keys on the RC027 for more than 10 seconds). If your TV works

on all or most of the keys on your RC027, you have entered a suitable Device Code. Go to step 11.

(Note: Your RC027 will only operate functions controlled by your original remote nor are the supplied codes guaranteed to operate all these functions)

TV Set up by manually entering code continued overleaf

3