POWER SUPPLY

GENERAL OPERATION

RADIO

AC MAINS

1.Check if the mains voltage as shown on the type plate on the base of the set, corresponds to your local mains voltage. If it does not, consult your dealer or service organisation.

2.If your set is equipped with a voltage selector, adjust it so

that it matches with the local power.

3. Connect the power cord to the MAINS outlet and the MAINS inlet.

The mains supply is now connected and ready for use.

4.To switch off completely, withdraw the power cord from the mains outlet.

Disconnect the power cord from the wall outlet to protect your set during heavy thunderstorms.

English

GENERAL OPERATION

1.To switch on the set, adjust the source selector.

2.Adjust the sound using the VOLUME and DBB controls.

3To switch off the radio, adjust the source selector to the TAPE/POWER OFF position, with the cassette buttons released.

RADIO RECEPTION

1Set the source selector to RADIO.

2Adjust the sound using the VOLUME and DBB controls.

3.Select the wave band FM/AM using BAND.

4.Tune to a radio station using TUNING.

5.To switch off, set the source selector to the TAPE/POWER OFF position (with the cassette buttons released).

To improve radio reception

For FM, pull out the telescopic antenna.

Incline and turn the antenna. Reduce its length if the signal is too strong (very close to a transmitter).

For AM, the set is provided with a built-in antenna so the telescopic antenna is not needed. Direct the antenna by turning the whole set.

PAUSE

STOP-OPEN

 

SEARCH

PAUSE

STOP-OPEN

 

SEARCH

9

Page 9
Image 9
Philips 1007 manual Power Supply General Operation, AC Mains, Radio Reception, To improve radio reception