Philips 107B7 manual 17” CDT Color Monitor, Color for resin/paint, Resins, If paint is used

17” CDT Color Monitor 107B7

5.5 Color for resin/paint

Per Philips make-up sheet

5.6Resins

•RoHS requirements.

•WEEE requirements.

5.7If paint is used

•RoHS requirements.

•WEEE requirements.

5.8Plastic mold tooling

•Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate marks, ejector marks, etc.).

•Painting to cover up cosmetic defects due to molding is strongly discouraged.

5.9Plastics flammability

•All Plastics expect Base / Pedestal to be Flame Retardant UL 94-V0 or Better (if monitor weighs less than 18kg; UL94-V0 is OK).

•Base / Pedestal to be Flame Retardant UL 94-HB.

•All major plastic parts (bezel, back cover) need to be molded from same resin. Base / Pedestal otherwise specified.

5.10Texture/Glossing of housing

•The texture area and texture no. should follow Philips make-up sheet.

•The exterior surfaces shall have a uniform texture.

•Philips must approve the mold texturing.

•Detail document for texture refer to UAN-D249.

•< = 20 gloss units

5.11Tilt/Swivel Base ranges

•	Tilt Range -	Up = 14° ± 1°, Down = 3.5° ± 1°
•	Swivel Range -	± 90°

•Base should not break plastic when attempting to rotate it past the stops. 74