Philips 107B7 manual 17” CDT Color Monitor, DDC Instructions, System and equipment requirements

17” CDT Color Monitor 107B7

4-4DDC Instructions

128 bytes EDID Data (Hex):

	00	01	02	03	04	05	06	07	08	09	10	11	12	13	14	15
0	00	FF	FF	FF	FF	FF	FF	00	41	0C	1D	00	01	00	00	00
16	01	0F	01	03	68	20	18	78	2B	9E	A8	A1	54	46	99	24
32	0E	48	4C	A5	EF	00	31	59	45	59	61	59	71	4F	81	80
48	81	59	A9	40	A9	45	EA	24	00	60	41	00	28	30	30	60
64	13	00	36	E6	10	00	00	1E	00	00	00	FF	00	41	55	30
80	35	30	31	30	30	30	30	30	31	0A	00	00	00	FD	00	32
96	A0	1E	56	12	00	0A	20	20	20	20	20	20	00	00	00	FC
112	00	50	48	31	30	37	42	37	0A	20	20	20	20	20	00	2E

Take 105G7 DDC writer for example 1.General

DDC Data Re-programming

In case the main EEPROM with Software DDC which store all factory settings were replaced because a defect, repaired monitor’ the serial numbers have to be re-programmed.

It is advised to re- soldered the main EEPROM with Software DDC from the old board onto the new board if circuit board have been replaced, in this case the DDC data does not need to be re-programmed.

Additional information:

Additional information about DDC (Display Data Channel) may be obtained from Video Electronics Standards Association (VESA). Extended Display Identification Data (EDID) information may be also obtained from VESA.

2.System and equipment requirements

1.An i486 (or above) personal computer or compatible.

2.Microsoft operation system Windows 95/98,etc.

3.Newphl.exe program

4.(105G7)S554BPHL.ddc EDID program.

5.Software DDC Alignment kits shown as fig 1.

The kit contents: a. DDC board x1 b. Printer cablex1 c. D-Sub cable x1 d. 12V DC input

Note: The Newphl.exe is a MS-DOS -based program, which cannot be run in windows.

17