If Cable TV signal into your home is a
single cable (75 ohm) the connection
to the TV is easy.
1
Connect the Cable TV cable
directly to the 75Ωjack on the
TV.
Basic Cable TV Connection
Basic Antenna Connection
75Ω
75Ω
Cable TV Signal
RF Coaxial
Cable 75Ω
Rear of TV
Acombination antenna receives normal
broadcast channels (VHF 2-13 and
UHF 14-69). Your connection is easy
since there is only one 75Ω(ohm)
antenna plug on the back of your TV -
and that’s where the antenna goes.
1If your antenna has a round
cable (75 ohm) on the end, then
you're ready to connect it to the
TV. Go to step 2.
If your antenna has flat twin-
lead wire (300 ohm), you first
need to attach the antenna wires
to the screws on a 300 to 75
ohm adapter (not supplied with
TV).
2Push the round end of the
adapter or antenna cable onto
the 75Ωjack on the rear of the
TV. If the round end of the
antenna cable is threaded, screw
it down tight.
1
75Ω
75Ω
Combination
VHF/UHF Antenna
(Outdoor or Indoor)
Twin Lead
Wire
Round Cable 75Ω
Rear of TV
If no Video Signal is present, the TV
will display a “BLUE” screen and shut
itself off in about 5 minutes. If the TV
is tuned to the AV channel and there
is no Video Signal present, the screen
will remain black and the TV will shut
itself off in about 5 minutes.
Use Auto Program as described on
panel 9 to set up channels that are
available in your area. Use the CH +/–
buttons to scan available channels.
Helpful Hints