Philips 200S4 Safety and Troubleshooting Information, Safety precautions and maintenance

Safety and Troubleshooting Information

•Safety Precautions and Maintenance

•Installation Locations

•FAQs

•Troubleshooting

•Regulatory Information

•Other Related Information

Safety and Troubleshooting Information

Safety precautions and maintenance

WARNING: Use of controls, adjustments or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards and/or mechanical hazards.

Read and follow these instructions when connecting and using your computer monitor:

●Unplug the monitor if you are not going to use it for an extensive period of time.

●Unplug the monitor if you need to clean it with a slightly damp cloth. The screen may be wiped with a dry cloth when the power is off. However, never use alcohol, solvents or ammonia-based liquids.

●Consult a service technician if the monitor does not operate normally when you have followed the instructions in this manual.

●The casing cover should be opened only by qualified service personnel.

●Keep the monitor out of direct sunlight and away from stoves or any other heat source.

●Remove any object that could fall into the vents or prevent proper cooling of the monitor’s electronics.

●Do not block the ventilation holes on the cabinet.

●Keep the monitor dry. To avoid electric shock, do not expose it to rain or excessive moisture.

●When positioning the monitor, make sure the power plug and outlet are easily accessible.

●If turning off the monitor by detaching the power cable or DC power cord, wait for 6 seconds before attaching the power cable or DC power cord for normal operation.

●To avoid the risk of shock or permanent damage to the set, do not expose the monitor to rain or excessive moisture.

●IMPORTANT: Always activate a screen saver program during your application. If a still image in high contrast remains on the screen for an extended period of time, it may leave an 'after-image' or 'ghost image' on front of the screen. This is a well-known phenomenon that is caused by the shortcomings inherent in LCD technology. In most cases, the after- image will disappear gradually over a period of time after the power has been switched off. Be aware, that the after-image symptom cannot be repaired and is not covered under warranty.

●If your monitor gets wet, wipe it with dry cloth as soon as possible.

●Do not use organic solvents, such as alcohol, etc., to clean your monitor.

●If foreign substance or water gets in your monitor, please turn the power off immediately and disconnect the power cord. Then, remove the foreign substance or water, and send it to the maintenance center.

●Please use approved power cord provided by Philips all the time. If your power cord is missing, please contact with your local service center. (Consumer Information Center)

●If there is any need for any document for repair or integration, please contact with your local service center. (please refer to the chapter of "Consumer Information Center")

●For transportation information, please refer to "Physical Specifications".

file:///D/My%20documents/dfu/J/english/200p4/safety/safety.htm (1 of 2)7/9/2004 12:35:52 PM