Philips 20MC4206 quick start To update your memorized and non-memorized channels, see

T9201UB_EN 3/7/06 11:06 AM Page 17

The unit selects available TV channels automatically when you connect an Antenna or Cable TV signal to it. To reset TV channels, see page 20.

If you are using a Cable Box or Satellite Receiver, you do not need to set channels at the TV/DVD.

1 Press STANDBY-ONy to turn on the TV/DVD.

2 To watch TV, press CH. ▲/▼ to select memorized channels. Memorized channels are those that appear when you flip through channels. If a channel is skipped, you still can use the Number buttons to select it. This is a non-memorized channel; it may have weak reception in your area.

To update your memorized and non-memorized channels, see page 19.

Remember, if you are using a Cable Box/Satellite Receiver, set the TV/DVD to channel 3, 4 or AUX. Change channels at the Cable Box/Satellite Receiver.

3 Press VOL. X/Y to adjust the volume.

VOLUME 20

Watching TV 17

1 STANDBY-ON

OPEN/CLOSE

1 2 3

4 5 6

7 8 9

CLEAR+100

0+10

PREV NEXT

PLAY

STOP SLOW PAUSE

RETURNTITLE

ENTER

2	DISC		SET-UP
	MENU
	PICTURE	CH.	VOL.	3
	/SLEEP
	SELECT
	MODE	DISPLAY	MUTE

Helpful Hint

•If the TV screen shows snow noise and there is no operation for more than 10 seconds, “HELPFUL HINTS” appears.

- HELPFUL HINTS -

1.PLEASE CHECK TO SEE IF THE ANTENNA/CABLE/ SATELLITE IS PROPERLY CONNECTED.

2.DID YOU PERFORM

“AUTO CH PROGRAMMING”? 3.PLEASE REFER TO FRONT

PAGE OF THE OWNER’S MANUAL OR REAR PANEL FOR SUPPORT LINE INFORMATION.