Philips 20XL Hair Length SELECTOR,WITH Guide Comb, Before Trimming Hair, Trimming Your Hair

3

HAIR LENGTH SELECTOR,WITH

GUIDE COMB

IMPORTANT

The Hair Length Selector allows you to adjust to seven different hair lengths, so that you may achieve the exact length and look you want.

1To adjust settings, push Hair Length Selector to desired setting.

2Hair Length Selector will “click” and automatically lock into place at each setting (Fig. 3).

TRIMMING

Before Trimming Hair

1Be certain Hair Clipper is clean (free of hair and debris).

NOTE: If cutter blades are running slowly or do not move, they may be dirty and clogged.

Clean following MAINTENANCE instructions.

2 Seat person having hair trimmed so that the top of

their head is at your chest height.

4

5

4Hold Hair Clipper with Guide Comb flat against the scalp (Fig. 4).

5Start at the sides of the head. Move Hair Clipper up slowly against direction of hair, lifting it up and outward through hair, cutting a small amount at a time.

6Continue trimming at neck and back of head (Fig. 5).

7If you want hair shorter, change Hair Length Selector to a lower setting and follow same steps.

•Start at higher setting (#6 or #7), to prevent trimming off too much hair.

•As you become familiar with the settings, adjust Hair Length Selector to desired trimming length (see settings below).

	Place towel around their neck.
3	Comb hair well to remove all tangles. It is not
	necessary to wash hair before trimming. For best
	results, use on dry hair.
4	For accurate cutting control, hold Hair Clipper in
	a comfortable grip.This is important for a precise,

6	Trimming Top Of Head
1	Remove Guide Comb Attachment.
2	Comb hair forward over eyes.

	SETTINGS
7	leaves hair approximately	21 mm/.84 inches		in length
6	leaves hair approximately	18 mm/.72	inches	in length
5	leaves hair approximately	15 mm/.6	inches	in length
4	leaves hair approximately	13 mm/.52	inches	in length
3	leaves hair approximately	10 mm/.4	inches	in length
2	leaves hair approximately	7 mm/.28	inches	in length
1	leaves hair approximately	4 mm/.16	inches	in length

	even cut.
5	For best results, comb hair often during trim to be
	certain the cut is even.
6	If using Hair Clipper for the first time, trim only a
	small amount of hair at a time, until you become
	comfortable with Hair Clipper and the Hair
	Length Selector.

IMPORTANT: When using Hair Clipper without Comb Attachment, use a slow, smooth motion to prevent trimming off more hair than desired.

Trimming Your Hair

1Use Hair Clipper with Guide Comb.

2Comb hair so that it falls into its natural direction.

3Begin at highest setting (#7) on the Hair Length Selector.

After you are familiar with the Hair Clipper, you may easily choose between the 7 settings for your desired length.

3 Using barber comb, lift a small section of hair at a

time and grasp hair between two fingers.

The amount of hair you wish to cut should extend

beyond your fingers (Fig. 6).

4Trim and blend hair using scissors or Hair Clipper.

5Continue this procedure, working from the front to the back of head.

As you work to the back, you may gradually cut hair shorter by holding fingers closer to head when grasping sections of hair.

6Comb hair often to remove trimmed hair and to check for uneven areas.