Philips 22PFL4505D Switching on and initial setup, Press OK to finish Settings assistant

Switching on and initial setup

Before you switch on the TV, check that the AC power cord is properly connected. Press .POWER at the right side of the TV, or press . on the remote control.The TV normally takes 25-30 seconds to start up and the following screen appears the first time you turn on the TV.

InitialI iti l Setupt

Select your menu language.	English
Seleccione el idioma para el menú.	Español
Sélectionnez la langue du menu.
	Français

Select	OK OK	MENU
		Skip

Follow the on-screen instructions to select your language and complete your TV setup. Installation takes approximately 10 minutes.

Press Í or Æ to select the desired mode for energy saving, then press OK.

InitialI iti l Setupt

Select “Retail” or “Home” for your location.

Retail Home

Select	OK OK	SETUP
		Exit

Select [Retail] if you want backlight to be brighter. Select [Home] to reduce power consumption.

You must set [Home]. Otherwise, personalized picture and sound settings will not be memorized after the unit goes to stand-by mode.

•Select [Retail], the unit will be set up with predefined setting for retail displays. In this setting, the power consumption may possibly exceed the limited requirement of the ENERGY STAR® qualification.

•Select [Home], the unit will be set to maximize energy efficiency. Picture and sound settings can be adjusted and saved as per your personal preferences.

Press OK to begin [Settings assistant].

Settingstti assistanti t t

Settings assistant helps you customize picture settings. You will see a series of test pictures where the right side and left side differ. Select the side that is most pleasing to you with the Left/ Right keys.

BACK	Back	MENU
OK Next		Exit

Press Í or Æ 5 times to select the side of the pictures that is the most pleasing to you. then press OK.

E n g l i s h

Left side Right side

1/5 Select the picturei settingi thatt t you preferf ..

Select	BACK	Back	MENU
	OK Next		Exit

Press OK to finish [Settings assistant].

Settingstti assistanti t t

You have set up your viewing preferences.

OK Store	BACK	MENU
	Back	Exit

Finish the Setup.

Note

•If you are not receiving a signal from your cable service, contact the CATV provider.

•If you press . or MENU during autoprogram, this setting will be canceled.

•The initial autoprogram function can be executed for either [Antenna] or [Cable] only once.When you change the connection (Antenna / Cable), set autoprogram again. (Refer to page 24.)

•If there is no signal input from the antenna terminal and no operation for several seconds after you turn on the TV, [Helpful Hints] appears. Follow the instructions listed on the TV screen.

EN 11