Philips 35LC, 25LC important safety instructions Outlining, Short CUT, Crew CUT

8. OUTLINING

Outlining helps to give a smooth, well-groomed line along edge of hair.

1.Remove Guide Comb from Hair Clipper.

2.Comb hair so that it falls into its natural direction.

3.Hold Hair Clipper over ears with corner edge of Hair Clipper against hair line (Fig. 7).

4.Angle upper edge of Hair Clipper at a safe distance from top of ear. Slowly and carefully follow desired out- line of hair over and behind ears and down sides of neck.

5.For longer hair styles, where hair is worn over the ears, use scissors to trim off as much hair as desired.

6.For defining sideburns and back of neck, hold Hair Clipper as shown against the skin and move it down slow- ly (Fig. 8).

9. SHORT CUT

1.Use Hair Clipper with Guide Comb.

2.Comb hair so that it falls into its natural direction.

3.Choose desired setting on Hair Length Selector.

4.Cut hair against direction in which it grows starting from the front to crown of head (Fig. 9).

5.Cut up sides to crown of head (Fig. 10).

6.Cut up the back to the crown (Fig. 11).

9

7.If necessary, repeat this cut- ting to be certain hair is uniform in length.

8.For smooth, even cutting, especially with coarse, heavy hair, allow Hair Clipper to cut through hair - do not force it through hair faster than it can cut.

9.Finish this cut using the OUT- LINING method to smooth out hair line.

10. CREW CUT

1.Use Hair Clipper with Guide Comb.

2.Comb hair so that it falls into its natural direction.

3.Begin with highest (#7) setting on One Step Select Switch.

■You may want to adjust this setting as you become famil- iar with the settings.

4.Hold Guide Comb flat against head and slowly move it through hair.

5.Cut hair up the back to crown of head.

6.Cut straight up sides and from back of ears in a line even with sides of face.

Leave hair long on top from the front to the crown (Fig. 12).

7.To give a “flat top” look, hair on top of head must be cut over a comb or between fin- gers.

8.Lift hair with comb or fingers to desired length and cut hair with scissors or with Hair Clipper without Guide Comb (Fig. 13).

9.Comb hair and check for uneven spots. Finish this cut using the OUTLINING method for sideburns and neckline.

7 8

10 11

12 13