Initial installation
aOpen up the battery compartment of your remote control
and place the batteries in it as shown in the picture.
bClose the battery compartment.
cIf the aerial (antenna) has been connected to the
TV-VIDEO Combi, press the OK button.
’Automatic TV channel search’ starts. This picture will
appear on the screen:
Searching...
CHANNELS FOUND:
//////,,,,,,,,,,,,,,,,,,,,,
Wait until all TV channels have been found. This can take
several minutes.
When ’autoinstall’ is ready, ’Installation
comp.’ will briefly appear on the TV screen.
DIf you have connected a decoder, you must install it
as described in the next section.
DIf you have connected a satellite receiver, please
read the section ’satellite receiver’.
Allocating a decoder
Some TV stations will send coded TV channels, that you can
only watch when you use a decoder. You can connect such a
decoder (descrambler) to your TV-VIDEO Combi. With the
following function, the connected decoder will automatically
be activated for the TV programme you want to watch.
aChoose the TV channel on which you wish to use the
decoder with the Pqor Prbuttons on the TV-VIDEO
Combi or the number buttons 0-9 on the remote control.
bPress the MENU buttonon the remote control. The main
menu will appear.
cSelect the line ’Installation’ with the Bor
Abuton and confirm with the Cbutton.
dSelect the line ’Manual store’ with the Bor
Abutton and confirm with the Cbutton.
eSelect the line ’Decoder’ with the Bor Abutton.
MANUAL STORE
Channel/Frequency FREQU.
TV system PAL I
Search 125
Fine tuning (,,,,,,n=,,,,,,$
Name edit xxx
Programme number 01
Decoder OFF
NICAM ON
ã Exit:
« press MENU
fSelect function ’ON’ with the Dor Cbutton. When
you select ’OFF’, the function will be switched off.
gConfirm with the OK button.
hTo end, press the MENU button.
Your decoder has now been allocated to this TV channel.
2. INSTALLING YOUR TV-VIDEO COMBI5