Philips 2760 manual Removable Loudspeakers, Connecting the Speakers, General Operation

English

AZ 2765 /17 page 10

SPEAKERS

REMOVABLE LOUDSPEAKERS

Taking off the speakers

Keep the lever (found on the back corner of the speaker) pressed and slide the speaker upwards.

Attaching the speakers

Slide the speakers from above into the sleeves on the sides of the cabinet. The speakers will click into position.

CONNECTING THE SPEAKERS

1.Connect the right speaker to the R terminal, with the red marked wire to "+" and the black wire to "-".

2.Clip the exposed portion of wire into the corresponding color terminal.

3.Repeat the wiring procedure for the left speaker to terminal L, making sure that you connect the red wire to "+" and black to "-".

Note:

–Speakers with an impedance of 4 Ohms or higher other than as supplied may be used instead. Speakers with a lower impedance, however, are unsuitable and will damage your set.

–When headphones are inserted into the headphone jack the speakers are disconnected.

GENERAL OPERATION

1.Press POWER to on position.

– A source indicator lights up.

2.Select and press your source button CD, TUNER or TAPE.

– The selected source indicator lights up.

3.Operate sound source according to the instructions of the respective chapter about the function.

4.Adjust the sound using the VOLUME and DBB controls.

–For AZ 2765 model only: The volume level is briefly indicated in the display when you press VOLUME 4 , 3 on the set or remote control.

5.Press POWER to off position to switch off the set.

– The selected source indicator goes out.

+	R	–	+	L	–
		SPEAKERS 4

POWER
	AZ2765 CD RADIO
	CASSETTE RECORDE
DBB
SHUFFLE	CD
	TUNER

10