Connections
The television has 2 SCART connectors at the back of the set (EXT1 and EXT2). The EXT1 connector (the top one) has audio video inputs/outputs and RGB inputs.
The EXT2 connector has audio video inputs/outputs and
Video recorder
CABLE 
EXT 2
Other equipment
CABLE 
Carry out the connections shown opposite, using the EXT2 connector. Use a good quality SCART connector cable.
If your video recorder does not have a SCART connector, the only possible connection is via the aerial cable.You will therefore need to tune in your video recorder’s test signal and assign it programme number 0 (refer to manual installation p.5).To reproduce the video recorder picture, press 0.
Video recorder with Decoder
Connect the decoder to the second SCART connector of the video recorder.You will then be able to record scrambled transmissions. See also the SETUP menu (following page).
Satellite receiver, decoder, DVD, games, etc. Carry out the connections shown opposite.To optimise picture quality, connect the equipment which produces the RGB signals (digital decoder, DVD players, games, etc…) to EXT1, and the equipment which produces the
To select connected equipment
Press ~ to select EXT1 or EXT2.
Most equipment (decoder, video recorder) carries out this switching automatically.
Side connections
* 
AUDIO 
VIDEO 
S•VIDEO
Make the connections as shown opposite.With the key ~, select FRONT.
For a monophonic device, connect the audio signal to the AUDIO L input. Use the e key to reproduce the sound on the left and right speakers of the TV set.
Headphones
The @ ” # keys are used to adjust the volume. Press the
mkey to mute the sound on the TV set (see also sound settings, page 6).
The headphone impedance must be between 8 and 4000 ohms.
Amplifier
AUDIO |
To connect to a
10
