Philips 24PFL4505, 32PFL3305/V7, 24PFL5505/V7 user manual Use your TV, Switching on, Switching off

4 Use your TV

Switching on

Follow the instructions on this page on how to switch on your TV set and the remote control before going on to following pages describing how to use the channel set-up procedure.

1.Insert two AAA batteries in the remote control.

Precautions on using batteries:

-Only use the battery types specified.

-Make sure you use the correct polarity.

-Do not mix new and used batteries.

-Do not use rechargeable batteries.

-Do not expose batteries to excessive heat such as sunshine, fire or the like, throw them in a fire, recharge them or try to open them, as this could cause them to leak or explode.

-Remove the batteries from the remote control if you are not using it for a long period of time.

2. Connect the power cable to a mains socket. (If the power cable is not connected to the television, please first connect the power cable to the television.)

Your TV set should only be connected to an AC supply. It must not be connected to a DC supply. If the plug is detached from the cable, do not, under any circumstances, connect it to a mains socket, as there is a risk of electric shock.

Note: The figures are for representation only. The location of the power socket at the back of the television might differ depending on the model.

3. Connect the outside aerial or cable network to the ANTENNA IN socket at the back of the TV set.

The aerial socket (75 OHM - VHF / UHF / cable) can be used for connecting an external aerial or other equipment fitted with a modulator (video recorder, satellite receiver, etc.). We recommend that you do not connect other equipment (video recorder, satellite receiver, etc.) to your TV set to begin with, so as not to complicate the set-up procedure with the additional steps involved. Connect them when you have finished setting up the channels.

4. Switch the TV on by pressing the power button.

Note: The location and name of the power button on the TV may vary according to TV model.

If the TV set is in standby mode, press the button on the remote control or the

CH+/- buttons on the TV set to turn on the TV.

Switching off

To put the TV set into standby mode, press the button on the remote control.

The TV set remains powered up, but with low energy consumption.

To switch off the TV set, press the power button.

8 EN