Symptom Possible cause/Remedy
No picture <Verify if the supplied cables are connected properly. (The aerial cable to the
TV,the other aerial to your recorder,the power cables, ..)
<Verify if you selected the correct source.
<Verify if the child lock has been switched off.
Poor picture <Verify in the Manual installation menu if you have selected the correct TV
system.
<Verify if your TV or house aerial isn't located too close to loudspeakers,
non-earthed audio equipment or neon lights, etc.
<Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of
the aerial.
<Is the picture or teletext unrecognisable.Verify if you have entered the
correct frequency.See Installation, Manual installation,p. 26.
Poor colour <Select Factory settings in the Installation menu.
<Verify the connections between the optional equipment and the TV.
No sound <Verify if the volume isn't at minimum.
<Verify if the sound hasn't been muted with the ¬key.
<Verify the connections between the optional equipment and the TV.
The remote does <Verify if the remote is set correctly for the equipment your are using.
not function <Verify if the batteries are not dead.Replace the batteries.
You can still use the keys at the right side of the TV.
<Select TV mode on your remote control.
<When pressing a key and some key leds are blinking with a higher speed
and lower intensity than in a normal working condition,and your TV does
not react on the key press,remove the batteries out of the remote control
and put them back again.
The remote of <The infrared signals of the screen may influence the reception sensibility
connected equip- of other peripherals.
ment does not Solution: replace the batteries of the remote of other peripheral equipment.
function well
No photo or music <Verify if the source complies with a supported code.
play or in poor
quality
No stable or not <Verify if you have selected the correct VGA mode in your PC.
synchronised VGA See Connect a PC, p. 45.
picture <Verify the connections between the PC and the TV.
No solution found <Switch off your TV off and then on again once.
for your picture or Never attempt to repair a defective TV yourself.
sound problem Verify with your dealer or call a TV technician.
Red blinking led <Unplug the mains cord for 10 seconds and insert it in again.
49
Troubleshooting EN
2560.5 en 14-11-2006 14:12 Pagina 49