IR Sensor

The remote control of the TV uses RF (radio frequency) to
send its commands to the TV. With RF, you do not need to
point the rem ote control at the TV.
However, th e TV can al so receive commands from a remote
control that us es IR (infrared) to send commands. If you use
such a remote control, always make sure you point the remote
control at the infrared sensor on the front of the TV.

Pairing

This remote control uses radio frequency (RF) to send its
commands to the TV. Contrary to remote controls usin g
infrared signals, with this remote control you can send
commands without pointin g at the TV.
With n o need to point the re mote con trol, using the keyboard
on th e back or s endin g comm ands from an other room -
changing the volume or s witching channe ls - is easy.
Additionally, the TV can notify you when the battery power of
the remote control is low.
Pairing the remote control
For the remot e control to com muni cate wi th th e TV , both TV
and rem ote control should b e paired with each other. Once
paired, you cannot us e the remote control to control anothe r
TV.
When you starte d the initi al TV install ation, the TV invite d you
to press the OK key, and by doing so, the pairing was done.
When you swi tch off the TV, the pa iring is store d. You can pair
up to 5 remote controls with this TV.
Pairing again
You can pair another remote control with this TV.
The method to pair a remote control is different for a remote
control already paired with another T V compared with a
remote control t hat is not pa ired ye t.
• The remo te control is paired with another TV
To pair, hold the Remote control close to the Philips logo
(about 10cm) and press the * Red and * Blue key at the
same time. A message will appear if pairing is successful.
• The remo te control is not paired yet
To pair, hold the Remote control close to the Philips logo
(about 10cm) and press OK. A message will appear if pairing is
successful.
For retail
To pair a new - not yet paired - TV with a remote control
which is already paired with another TV, hold the Remote
control close to the Philips logo (about 10cm) and press the
* Red and * Blue key at the same time. A message will
appear if pairing is succe ssful.

Batteries

The TV will notify you when the battery power of the remote
control is low.
To replace the batteries, open the battery compartment on
the keyboard side of the remote control.
1 - Use a toothpick or other small, blunt object and press the
small, square shaped release button to open the lid.
2 - Press the small lever next to the blue clip to release the
clip.
3 - Replace the old batteries with 2 type AAA-LR03-1.5V
alkaline batterie s. Make sure the + and the - ends of the
batteries li ne up correctly.
4 - Press the blue clip down until it clicks.
5 - Reposition the battery cover and press it until it clicks.
Put the remote control down for about 15 seconds to calibrate
the pointer.
Remove the batteries if you are not using the remote control
for a l ong tim e.
Dispos e of batteri es a ccording to the end of us e dire ctive s.
In Help, press * List and look up End of use for more
information.

Cleaning

Your remote control is treated with a scratch-resistant coating.
To clean the remote control, use a soft damp cloth. Never use
substances such as alcohol, chemicals or household cleaners
on th e rem ote c ontrol.
3.3
TV chan nels

Watching TV channels

Switch channels
To watch TV channels, press t TV. The TV tunes to the
TV channel you last watched.
24 TV / TV channels