Using Manual Converge: Multipoint Red/Blue
The Multipoint Red/Blue convergence controls allow you to adjust picture convergence at specific points on the TV screen.
Note: Allow the TV to warm up for 20 minutes before adjusting convergence. Adjust Converge Red or Converge Blue before using the Multipoint Red/Blue controls. See the previous page.
Select MULTIPOINT RED or MULTIPOINT BLUE in the MANUAL CONVERGE menu.
Press the cursor right to enter navigate mode.
Use the cursor left, right, up or down to move to a cross hair that has a colour outline.
Press the OSD (Status/Exit) key to enter adjust mode.
Use the cursor left, right, up or down to adjust the cross hair until the colour outline is gone.
Press the OSD key to return to navigate mode.
Repeat steps
For your multipoint adjustments to be stored in the TV’s memory, you must activate SAVE MULTIPOINT.
Note: If you are not satisfied with the adjustments you just made and want to start over, you can use the UNDO MULTIPOINT control. This control allows you to undo the adjustments, but only if you use it before saving.
To save your multipoint adjustments: Select SAVE MULTIPOINT and press the cursor left or right.
To undo your multipoint adjustments: Select UNDO MULTIPOINT and press the cursor left or right.
To restore the TV’s picture convergence to factory settings, select RESTORE FACTORY and press the cursor left or right.
Press the MENU key to return or the OSD key to switch the menu off.
13
