Philips 608669 manual Machine Operation, Electronic Sensor System

OPERATION

3.Pull and turn quick-release hook to remove power cord (Figure 6).

FIG. 6

4.Plug power cord into a grounded wall outlet (Figure 7).

Grounded

3 Hole Outlet

Ground Pin

FIG. 7

FOR SAFETY: Do not operate machine unless cord is properly grounded.

FOR SAFETY: Do not operate machine with the use of an extension cord.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless operator manual is read and understood.

1. Activate ON/OFF switch.

WARNING: Do Not Pick Up Flammable Or Toxic Materials, Burning Or Smoking Debris.

2.Lower handle to operating position by stepping on handle release latch (Figure 8).

NOTE: Brush motor will not start until handle is lowered.

FIG. 8

3.Begin vacuuming floor. Operate machine with a back and forth motion or “W” pattern.

4.To operate in the horizontal position, lower handle to the stop point and step on release latch again (Figure 9).

Upright	Operating
Position
	Position

Horizontal

Position

FIG. 9

5.To stop vacuuming, raise handle to the upright position and turn off power switch.

ELECTRONIC SENSOR SYSTEM

The machine’s Electronic Sensor System monitors the condition of the machine while operating. The sensor light, located on the bag compartment lid (Figure 10), will indicate the following conditions:

Green Light = Machine Functioning Properly.

ViperR Upright Vacuum Cleaner (06 03)

Home Find...

Go To..

7