OPERATION
Blinking Orange Light = Full Bag or Air Obstruction. Replace bag or remove air obstruction in vacuum hose.
Blinking Red Light = Brush Obstruction or Brush Height set too low (Amp. overload). Remove brush obstruction or readjust brush height.
3. Activate ON/OFF switch.
WARNING: Do Not Pick Up Flammable Or Toxic Materials, Burning Or Smoking Debris.
The wand’s hose expands up to 2.4m (8 ft) in reach (Figure 12)
FIG. 10
To reset sensor system, turn power switch off and then back on again.
NOTE: The vacuum motor is also protected by an internal thermal overload sensor. If motor temperature gets too high, the thermal sensor will shut off motor. Sensor will automatically reset when motor cools.
WAND OPERATION
The machine is equipped with a “ready to use” wand and crevice tool.
Contact local distributor for Optional Tool Kit #604802 Kit includes: Upholstery Tool and Dusting Brush.
1.Stand machine upright. When upright, the power to the brush motor automatically shuts off.
ATTENTION: When using the wand, keep machine upright to prevent possible carpet damage.
2.Detach wand from retainer clip and attach crevice tool located on carrying handle (Figure 11).
FIG. 11
FIG. 12
MACHINE MAINTENANCE
To keep machine in good working condition, simply follow machine’s daily, weekly and quarterly maintenance procedures.
FOR SAFETY: When servicing machine, unplug cord from wall outlet.
DAILY MAINTENANCE (Every 4 Hours of Operation)
1.Check filter bag for fullness, replace bag as needed. Do not reuse paper bags. Inspect optional cloth bag for tears or holes, replace if damaged.
2.Remove entangled debris from brush.
3.Inspect vacuum hose for damage and clogged debris.
4.Inspect power cord and strain relief for damage. Replace if necessary.
5.Wind power cord around cord hooks rather than loosely looped over handle.
6.Clean machine housing with an all purpose cleaner and damp cloth.
WEEKLY MAINTENANCE (Every 20 Hours of Operation)
1.Remove secondary filter and tap or blow off dust
8
Home Find...
Go To..
ViperR
Vacuum Cleaner
