18ENGLISH

Preparing Jet Clean System For Use

Important

Only use the razor,power plug,Jet Clean System and HQ200 cleaning solution provided to charge or clean razor.

Only use a Philips Norelco ‘XLCC’ model razor with the Jet Clean System.

Other Philips Norelco‘X’,‘XL’ or‘LC’ model razors DO NOT work with a Jet Clean System.

Empty the cleaning solution canister and thoroughly rinse the canister clean with warm water every 2 weeks.

The Jet Clean System thoroughly cleans but does not disinfect your razor, therefore, do not share razor with others.

Thecharging plug converts 100-240VAC to less than 24V DC.

Place the Jet Clean System on a flat, stable surface to avoid any leakage. Be careful not to tip or move the Jet Clean System if it is filled with the cleaning solution.

To avoid evaporation, do not expose cleaning solution to direct sunlight.

Remove the protective razor head cap from the razor before charging or cleaning the razor in the Jet Clean System.

Use this appliance for its intended household use as described in this manual.

ENGLISH 19

1Place the Jet Clean System on a flat,level surface.

C

 

Lift the transparent cleaning reservoir

2

 

 

 

from the Jet Clean System.

 

C

 

Turn the reservoir cap counterclockwise

 

3

 

 

 

(1) and remove from the cleaning

 

 

 

reservoir (2).

4Unscrew the lid on the Jet Clean Solution bottle (Model HQ200) provided with the razor. Remove the airtight seal by lifting up the tabs on the seal. Replace lid on the bottle making sure the lid is screwed on securely.

5Open lid and pour the Jet Clean Solution into the transparent cleaning reservoir. The reservoir can be completely filled with one

(1) bottle of the Jet Clean Solution (Model HQ200).Discard cleaning solution bottle after contents have been poured into the reservoir.

NOTE: ONLY USE PHILIPS NORELCO JET

CLEAN SOLUTION (MODEL HQ200)WITH

THE JET CLEAN SYSTEM. ANY OTHER

SOLUTION MAY CAUSE DAMAGE TO YOUR

RAZOR.

Page 10
Image 10
Philips 7800XLCC manual Preparing Jet Clean System For Use, Place the Jet Clean System on a flat,level surface, Reservoir