Philips 7800XLCC manual Jet Cleaning the Razor

20ENGLISH

C 6 The amount of cleaning solution in the transparent cleaning reservoir is visible on both sides of the Jet Clean System. When the level gets low, refill with Philips Norelco HQ200 Cleaning Solution.

◗The cleaning solution is automatically supplied from the reservoir to the cleaning canister through a special mechanism in the reservoir cap.

C 7 Replace cap on reservoir(2) and turn clockwise (1) making sure cap is screwed on securely.

◗The cleaning solution may foam if the reservoir level is too low.Discard remaining solution,rinse the reservoir with warm water from the tap and refill with new cleaning solution.

◗If you clean your razor every day, you should refill the reservoir approximately once a month.

C 8 Carefully lower the cleaning reservoir back into the Jet Clean System making sure the reservoir is properly aligned with the base unit.

Jet Cleaning the Razor

◗If the razor does not contain enough power for one (1) shave, the Jet Clean Cleaning System may not work properly. Charge the razor in the Jet Clean System before using it to clean your razor.

		ENGLISH 21
C		Connect the small plug to the Jet Clean
	1
		System. Connect the charging plug into
		any 100V to 240V AC outlet. Use only the
		charging plug provided.
	The razor holder automatically moves up to the
	highest position.
		Place the Jet Clean System on a
	2.
		flat, level surface. Fill the cleaning
		reservoir with cleaning solution (see
		‘Preparing Jet Clean System For Use’).
C		Remove protective razor head cap from
	3
		razor.

C 4	Place the razor head side down in the
	razor holder so that the razor head fits
	into the configuration shown inside the Jet
	Clean System. Gently press the base of the
	razor towards the back of the Jet Clean
	System so that the razor base fits snugly in
	place. Lock the razor into place by pushing
	the lever down completely.
The charging light will blink to indicate the razor
automatically begins to charge.

C 5 Press the ON/OFF button to start the cleaning cycle.

The cleaning light on the Jet Clean System starts blinking and the razor is automatically lowered into the cleaning solution.The razor stops charging while it is cleaning.