Philips 1250X, 1260X Cleaning the Shaving Unit, Hot water for a few minutes, Shaving head open

26ENGLISH

◗Never clean, remove or replace shaving unit while motor is on.

◗Do not apply pressure to shaving head combs. Do not touch razor heads with hard objects as this may dent or damage precision-made slotted combs.

◗Do not use razor if shaving head combs are damaged or broken. Facial injury may occur.

◗Do not use abrasives, scourers or aggresive liquids such as gasoline or acetone to clean the razor or Jet Clean System.

Cleaning the Shaving Unit

The razor heads may be quickly cleaned after each use by rinsing with hot water.Water from the tap should be on a hot setting, BUT BE CAREFUL TO TEST WATER FIRST SO AS NOT TO BURN OR SCALD HANDS.

◗Regular cleaning guarantees better shaving results.

◗While rinsing razor heads, water may drip out of the base of razor.This is a normal occurrence.

1Always turn razor OFF, remove from charging stand/Jet Clean System before cleaning.

C F	C 2	Rinse the shaving unit by running under
		hot water for a few minutes.

ENGLISH 27

	C 3	Using your thumb and forefinger, grasp the
		sides of the shaving head near the center
		of the shaving unit and pull each individual
		shaving head open.
C F	C 4	Rinse all three shaving heads and three
		hair chambers under hot tap water by
		letting the water run in and around all the
		openings for at least 30 seconds.

BE CAREFUL TO TEST WATER FIRST SO AS

NOT TO BURN OR SCALD HANDS.

5You can also brush the shaving heads and hair chambers with the brush supplied.

6Carefully shake off excess water and leave the shaving heads open to dry the shaving unit completely.

NOTE: Do not wipe or dry the shaving unit with a towel or tissue.This could damage the shaving heads.

C 7	Press each shaving head back onto the
	shaving unit. You will hear a ‘click’.