Philips 9P6444C1, 9P5544C1 manual Setting the Remote to Work Other Devices Search, Search Method

SETTING THE REMOTE TO WORK OTHER DEVICES - SEARCH

SEARCH METHOD

Your TV remote can be set to work various accessory

SATELLITE RECEIVER

devices (VCRs, Cable Converters, Satellite Receivers) by what is called the SEARCH method.

Note: The Search Method only works with devices equipped with

Channel Display Indicators or capability. If the "Direct Access" code number method (shown in the previous section) did not set your remote to work your accessory device, then follow the easy steps listed below.

BEGIN

1Turn ON the desired device. Press the correct VCR or ACC system button on the remote.

2 Stand at least six feet away

from the front of the accessory

device. Point the remote toward

the unit. HOLD DOWN the

SURF and the desired System

(VCR or ACC) buttons at the

same time. KEEP HOLDING

1

VCR

			06
CABLE TV	06	07	0708
CONVERTER			09
	06	0809
	070809
	Don't let the Accessory Device
	scan up more than five channels
	(in Search mode).		Six Feet
			(minimum)

3

BUTTONS DOWN.

3Watch the Channel Indicator on the unit. Channel Numbers will SCAN UP when the unit has been identified. This may take up to two minutes.

4Release the SURF and System (VCR or ACC) buttons as soon as channel numbers start to scan up. The code has been identified and the remote is ready to operate with the accessory device.

STOP

SMART HELP

Remember, a minute or two

can seem very long, but the code should be located within two minutes.

Don't let the accessory device scan up more than five channels. The remote may pass up the right code and another two minute search cycle will have to be repeated.

If no channel change happens within two minutes, repeat steps 1-4. Should a channel change still not occur, the remote will not work with the desired unit.

VCR		PLAY ▶		STATUS
REC•/Plus +
CLEAR				LIGHT
REW		MENU
	−	M	+	FF
◀◀
				▶▶
				PAUSE II
MUTE		STOP	■	SURF
		INFO
VOL				CH	2
		GUIDE
ON/OFF		POS	SWAP	FREEZE		4
				SIZE
2 TUNER PIP		1	2	3
A◀ ◀ B

TV/VCR 4 5 6

ENTER

SLEEP 7 8 9

SMART0

POWER VCR ACC TV

M O D E

2 4

Note: For TV remote’s equipped with a backlight option, the unit may “blink” or flash as the remote moves through its product code list. Once a product code has been identified and the buttons on the remote are released, the unit will blink twice.

44