Philips AD7000W/37 user manual Update firmware, Download the update file

6Update firmware

Note

•• You can only update the firmware from a PC/Mac.

Download the update file

www.philips.com/support

XXXX

XXXX. zip

1 On your PC/Mac, go to www.philips.com/ support.

2 Enter the model number to find the latest firmware upgrade file available.

3 Save the upgrade file to your hard drive.

Update from the configuration page

Warning

•• Always connect your AD7000W to AC power for firmware upgrade. Never power off your AD7000W during firmware upgrade.

Note

•• To use an Internet browser other than Apple Safari on your PC/Mac, remember to go to the Wi-Fi router configuration page and write down the IP address of your AD7000W. See the user manual of your Wi-Fi router for how to find the IP addresses of devices connected to the Wi-Fi router.

1 Power on AD7000W (see ‘Turn AD7000W on’ on page 12).

»» It takes about 35 seconds for the unit to boot up. During boot-up, the WI-FI SETUP indicator on the back of the unit blinks green quickly.

»» After boot-up, you can hear a beep

and the WI-FI SETUP indicator turns to green steadily. AD7000W is connected to the last configured Wi-Fi network automatically.

2 Make sure that AD7000W and your PC/ Mac are connected to the same Wi-Fi router.

3 Open Apple Safari on your PC/Mac, then select ‘Philips_Fidelio XXX’ from the Bonjour pull-down list.

•Or open any other Internet browser on your PC/Mac, then type in the IP address of AD7000W (available on the Wi-Fi router configuration page) at the address bar.

»» The AD7000W configuration web page is displayed.

E n g l i s h

EN 23